At least two of the available MakeCode Arcade handheld console’s have the facility to program two Light Emitting Diodes (LED’s) mounted on the console using the MakeCode editor.
KittenBot Meowbit
The Meowbit has two LED’s mounted at the top right corner of the console, just to the right of the power on/off switch.
LED1 - Green
LED2 - Red
The LED’s are not very big. The green LED shines through the outer casing but the red LED is very faint. You may have to remove the blue/orange outer casing to view them both better. The Green LED is to the left of the Red LED.
TinkerGen GameGo
The GameGo has two LED’s mounted in the center of the console just below the screen and labelled as indication LED’s.
LED1 - Blue
LED2 - Red
The LED’s are quite large and bright. The Red LED is to the left of the Blue LED.
Tester Operation
Press Button [A] – LED1 will light. Green on the Meowbit. Blue on the GameGo.
Press Button [B] – LED2 will light. Red on both consoles.
Press Button [Menu] – Both LED’s will flash on and off alternatively.